![]() Start by placing the SSD into the rubber grommets on the edge of the MacBook Pro followed by gently letting the SSD fall into its place in the bay.Line up the SATA connector with the SSD and the MacBook Pro, and attach them together.Also screw in the four Torx T6 screws for your SSD just like they were screwed in for the hard drive.Now attach the plastic tab to the SSD you will be installing.Also remove the transparent plastic tab.Use the Torx T6 tool included with the Data Doubler to remove the 4 Torx T6 screws on the side of the hard drives.Make sure to detach the SATA Power and Data connector carefully.Use the transparent strip on the Hard drive to pull out the hard drive from the hard drive area.Remove the retainer bar held in place by two black screws that is holding the installed hard drive in place.Disconnect the battery connector from the motherboard (logic board) with the nylon tool.Replacing the Hitachi 500GB 7200RPM Hard Drive with the OWC Mercury EXTREME Pro 6G SSD Gently lift the cover off the MacBook Pro.Remove all the screws starting with the longer screws.There are 10 small Phillips screws that need to be removed, three longer Phillips screws on the top right hand side of the MacBook Pro.Turn off your MacBook Pro, close it and turn it upside down.Opening up the Apple MacBook Pro 15″ Early 2011 Model ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |